Sizing

You can measure your ring size at home easily and use the global size chart below. For the best fit, consider choosing a size that allows for slight movement without feeling too loose.

Materials Needed: A strip of paper (about 1/2 inch wide and 4-5 inches long), scissors, a ruler, and a pen or pencil.

Steps:

1. Cut a strip of paper about 1/2 inch wide and 4-5 inches long.
   
   
2. Wrap the paper strip around the base of the finger you want to measure. Make sure the paper is snug but not too tight.
   
   
3. Use a pen or pencil to mark where the paper overlaps. Make sure the mark is distinct.
   
   
4. Unwrap the paper from your finger. Use a ruler to measure the length from the edge of the paper to the mark you made in millimeters (mm). This measurement is your finger's circumference.
   
   
5. Compare the measured length to a ring size in the chart below to determine your ring size. Match the measured circumference to the closest size on the chart.

• For accuracy, measure your finger at different times of the day as fingers can slightly change in size due to temperature and other factors. Take the average of these measurements for the most accurate result.
• If the measurement falls between sizes, it's usually best to round up to the nearest whole size, especially if you're unsure.
• Remember, the fit of the ring can vary depending on the width of the band. Wider bands usually require a slightly larger size than narrower bands.
• If you're unsure about the measurement or if the first attempt doesn't seem right, repeat the process to confirm the size.

Note: If you have any doubts or if the measurement seems inconsistent, it's always a good idea to visit a jeweller or use a ring sizing kit for a more accurate measurement.